|
Proper Introduction threads rules.
Joint Design Rules of Thumb
The length of thread engagement in a steel nut member should be equal to or greater than one full diameter of the bolt and be of comparable strength (i.e. If the screw is ¼” diameter, the thread engagement needs to be a minimum of ¼”).
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|