06-28-2022, 01:04 AM
|
#38 |
|
Registered User
Join Date: Jan 2016
Location: Hyderabad
Posts: 4,286
|
Proper Introduction threads rules.
Joint Design Rules of Thumb
The length of thread engagement in a steel nut member should be equal to or greater than one full diameter of the bolt and be of comparable strength (i.e. If the screw is ¼” diameter, the thread engagement needs to be a minimum of ¼”).
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts. |
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
All times are GMT -7. The time now is 08:25 AM.